OLE T5020 Tank Gauge Kit, +/-0.25%, 0.3m – 3m

Description

Made in the UK, OLE has been manufacturing high-quality tank gauges since 2001 and became part of HYTEK in 2021. Every OLE unit is designed, assembled, and tested in the UK to ensure reliable performance and long-lasting accuracy.

OLE tank gauges are suitable for all tank shapes and are trusted for their proven, dependable technology. ATEX-certified versions are available for use in hazardous environments, offering added safety and compliance. Depending on the model, accuracy is consistent to within +/-1% (C2020/Z2000/EX2020) or +/-0.25% (T5020/Z5020/EX5020).

Each tank probe uses an electronic pressure sensor with a 1″ BSPT male fitting, designed to be suspended approximately 50mm from the bottom of the tank for optimal readings. The OLE T5020 Tank Gauge Kit (0.3m – 3m) includes the tank gauge housing, pressure sensor with 1″ tank adaptor and junction box, providing everything required for straightforward installation and operation.

Key Features and Benefits

• Suitable with diesel, HVO, biodiesel, AdBlue®, water & antifreeze
• Suits tanks 0.3m – 3m high
• Other kits available for 3m – 5m (T5020-1A-5M) & 5m -10m high tanks (T5020-1A-10M)
• Complete kit includes tank gauge & tank probe (pressure sensor)
• Accuracy +/-0.25% of tank capacity
• High level alarm 90dB sounder
• Probe cable can be extended to 100m (CABLE-4-BLACK)
• Low level alarm light
• Electronic display with backlight (turns off after 1 hour)
• 1 gauge required per tank
• Weatherproof to IP55
• Gives continuous readout in litres & shows a % bar
• Power supply can be 230V, 110V or 24VDC
• Includes 4-20mA output & Modbus RS485 to connect to a BMS (building management system)
• Includes junction box (used to extend probe cable up to 100m) non ATEX OLE gauges low loss cable must be used

Options

• Choose bund probe/level switch (B8)
• If using the bund probe for AdBlue®, water or antifreeze choose (B8-ADBLUE)
• Water bottom sensor (T4020-B2)
• If extending the probe cable on non ATEX OLE gauges low loss cable must be used (CABLE-4-BLACK)
• PC software for setup (T4020-01) enables an engineer to set up & calibrate
• We can calibrate your gauge within 24 hours of receiving our tank questionnaire (CALIB-T5020)
• The relay board fits inside the gauge housing & it has 5x volt free outputs (R5), optional charge for us to fit this inside the gauge housing (R5 INSTALLATION)

AdBlue^® is a trademark of the Verband der Automobilindustrie e.V. (VDA). https://www.vda.de/de